JUST A LITTLE BIT COOL COLLAB INSTALLATION GUIDE
JUST A LITTLE BIT COOL SPECIALIST BOARD PRINT INSTALLATION
Your Just a Little Bit Cool collab print is easy to mount; see the following steps for guidance:
Hint: after you have super glued your ball mounts to the back of your print and the glue has dried, mark the sharp point of each ball with a vivid or pen then press against the wall to mark the point to screw in the mounting set clips - ensure your points are level.
SUPER GLUE
Super glue needs to adhere to plastic. We recommend the following product, sold through Bunnings:
RECOMMENDATIONS
We recommend consulting a qualified builder before installing.
INSTALLATION VIDEO
See Just a Little Bit Cool's Instagram page, stories for an installation video.
- Use a damp cloth to clean your wall. Let the wall dry completely before proceeding. This step is important because walls have dust particles and residue that could affect the adhesion of the wall decal.
- Use painter’s tape to mark on the wall where the top and sides of the print should sit. Peel 1" of the backing paper from the top edge and gently position it on the wall to preview the location. We suggest using a level to make sure the decal is straight.
- Slowly peel the backing paper away from the print while using your fingers to smooth from the centre to the outer edge of the decal to avoid air bubbles. Take your time.
NOTE
Our Just a Little Bit Cool collab Indoor Decals are made to adhere to smooth surfaces and will not adhere to walls painted with a dirt repellant finish. Please allow normal painted walls to dry for 3 weeks before installing your decal.